GLASS MICROFIBRE SYRINGE PRE-FILTERS


DESCRIPTION

    

Recommended for fast pre-filtration of samples with high particles load.
  • Incorporated glass microfibre filter fixed without adhesive to a MBS polymerisate housing.
  • Ready to use syringe filter.
  • Hydrophilic.
  • High flow rates.
  • High total throughput.
  • Low hold-up volume.
  • Up to 500 ml of sample.
  • Large filtration area and an optimized geometry of the filter support.
  • Luer Lock outlet making it possible to connect additional syringue fiilters.
  • Not autoclavable, sterilization only feasible by gamma irradiation or ethylene oxide.


top ^


TECHNICAL SPECIFICATIONS

Material filter
Glass microfibre Syringe
Material house
Meta acrylate butadiene styrene polymerisate
Pore
0.20
Colour code
white
Flow rate (1) ml/min
450
Bubble point
0.5
Filter diameter (mm)
28
Housing diameter (mm)
33
Filter area (cm²)
6.2
Hold up volumen (before/after bubble point)
0.5/0.25
Adsorption (2)
0.8-3 ug/cm2 with BSA, 8-12 ug/cm2 with gamma globulin
Connectors
Female luer lock inlet
Male luer lock outlet
Cytotoxicity
No inhibition with MRC-5 or L-929 cells
Endotoxins
< 0.06 EU/ml
Max. operational pressure (bar)
4.5
Busrt pressure (bar)
6
Max. temperature (ºC)
50

 

(1)Flow rate for water at Ap = 1 bar ( 100kPa, 14.5 psi)

 

top ^


APPLICATIONS

  • Pre-filtration of small volume liquids to avoid saturation of the small-porosity membranes.

top ^


ORDERING INFO

NON-STERILE

Units/Box  
100 JFV25100
500 JFV25500


top ^